4) You will need to have on hand bathtub repair tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
There are two, one on each side of the toilet, closet bolts which hold the toilet to the floor. If there are caps over the bolts, remove or pop them open. Using a small crescent wrench unscrew the nuts from the bolts. Alternate side to side when unscrewing this will be much more important when reinstalling the water line repair bolts but alternate anyhow.
This so impressed me, that I thought, here is the man who might fix my sink problem, and I told him about my kitchen sink. The look on his face was priceless, as he said, "Ridiculous! Sinks don't leak if they're new." He even showed me what to do. He took out a big heavy-duty screwdriver with a big flat-head blade and showed me. "This is what's probably lose." He put the blade of the screwdriver in a notch the size of a giant screw head that was right in the center of the drain basket where the plug sat in.
Clean the hole in the gutter railing first. It must be free of any debris, so you may want to clean the entire drain channel using a proper cleaner. In this way, you will have a clean surface area which will allow you to repair the hole more easily.
Remove the cap of the faucet using slip-joint pliers. Tape the teeth of the pliers to prevent damage of the surface. Remove the faucet cam washer and water line repair the rotating ball.
People who own rental properties are great ones to give you information. With all of the service people needed for maintenance on their units, they typically know who to call and what level of work they perform. Most property owners will be more than happy to give you the information you seek. In fact, they were probably in your shoes at one time.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.